Specifications

Product specifications

Category		SH-B123L (TS-HB43L)
Category		BD-ROM/DVD writer
Disc	Usable discs	BD: BD-ROM(DL), BD-R(DL), BD-RE(DL), BD Hybrid DVD: DVD-ROM(DL), DVD-R(DL), DVD-RW, DVD+R(DL), DVD+RW, DVD-RAM, DVD-Video, LightScribe DVD-R, LightScribe DVD+R CD: CD-ROM, CD-R, CD-RW, CD-DA, CD+E(G), CD-MIDI, CD-TEXT, CD-ROM XA, Mixed Mode CD, CD-I, CD-I Bridge (Photo-CD, Video-CD), Multisession CD (Photo-CD, CD-EXTRA, Portfolio), LightScribe CD-R
Disc	Disc diameter	3.15 inch or 4.72 inch (80 mm or 120 mm)
Interface support	Interface port	S-ATA
Interface support	Burst Transfer Rate	S-ATA 1.5 Gbps
Access time (random)	BD-ROM	210 ms
	DVD-ROM	150 ms
	CD-ROM	150 ms
Data transfer speed (max)	Media type	Write	Read
	BD-ROM	`–`	`CAV 12X`
	BD-R(DL)/BD-RE/BD-ROM DL	`–`	`CAV 8X`
	BD-RE DL	`–`	`CAV 6X`
	DVD+R	`CAV 16X`	`CAV 16X`
	DVD+RW	`ZCLV 8X`	`CAV 12X`
	DVD+R DL	`ZCLV 8X`	`CAV 12X`
	DVD-R DL	`ZCLV 8X`	`CAV 12X`
	DVD-R	`CAV 16X`	`CAV 16X`
	DVD-RW	`ZCLV 6X`	`CAV 12X`
	DVD-ROM	`–`	`CAV 16X`
	DVD-ROM DL	`–`	`CAV 12X`
	DVD-RAM	`PCAV 12X`	`PCAV 12X`
	CD-ROM	`–`	`CAV 48X`
	CD-R	`CAV 48X`	`CAV 40X`
	US-RW	`ZCLV 24X`	`CAV 40X`
	HS-RW	`CLV 10X`	`CAV 40X`
	CD-RW	`CLV 4X`	`CAV 40X`
Buffer memory		2 MB
Drive installation		Horizontal / Vertical
Operating environment	Temperature	41 ℉ ~ 113 ℉ (5 ℃ ~ 45 ℃)
Operating environment	Humidity	5% ~ 80% (RH)
Dimensions (width x height x length)		148.2 x 42 x 170 mm
Weight		750 g

Disc labeling time

Media type	Setting	Titles only	The entire label area (including graphics)
CD media	Best	Less than 3:30 min	Less than 28:00 min
DVD media	Best	Less than 3:30 min	Less than 30:00 min

Note

Does not support DVD-R for Authoring.
Cannot playback or record on both sides of a dual layer disc simultaneously.
Because the read/write capacity of the supported discs depends on the condition of the disc and the recording format of the drive, the read/write quality may not be perfect.
Severe vibration or external impact may decrease the quality of printed images.
Firmly install the product into the PC before use.
In case of a disc identification error message, thoroughly clean the surface of the disc where the label is presented and then start printing.
The quality of the printed image cannot be ensured if printing an image on the area which is already used for printing.
For more information on the writing, install CyberLink software and refer to the HELP section.
Specifications are subject to change without notice.

Top

FCC information to the user

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

Caution

Change or modifications not expressly approved by the manufacturer responsible for compliance could void the user’s authority to operate the equipment.

Top

Laser Standard

EN 60825-1:2007

Important

The product specifications above may be changed to improve device performance without prior notice.

Top